Datum first, lines second
A scriber is used to mark all lines on a metal surface, and its point must remain sharp to produce well-defined lines.
A divider is used to scribe circles or arcs and to mark a series of lengths such as hole centres, and it is made from tool steel or high-carbon steel.
1. What does marking out primarily achieve on a workpiece?
2. Which description best matches a datum in marking out?
3. How should a scriber point be maintained to produce clear lines on metal?
What is marking out in machining?
Scratching lines on a workpiece surface to indicate outlines or positions.
What is a datum in measurement?
A reference point, edge, or centre line for all dimensions.
How many datums are needed to position a point on a plane surface?
Two datums are required.
At what angle are two datums usually set to position a point?
They are usually at right angles to each other.
What is the purpose of a scriber on a metal surface?
To mark all lines on a metal surface.
Why must a scriber's point remain sharp?
To produce well-defined lines.
La fiche de révision couvre les notions essentielles de Workshop Hand Tools and Measurement. Elle est structurée par thématiques pour faciliter l'apprentissage et la mémorisation, avec des définitions clés, des explications et des synthèses.
Lire la fiche complète →Le QCM contient 24 questions à choix multiples avec corrections détaillées et explications pour chaque réponse. Idéal pour tester tes connaissances et identifier tes lacunes.
Faire le QCM (24 questions) →Revizly propose 56 flashcards interactives sur Workshop Hand Tools and Measurement. Chaque carte présente une question au recto et la réponse au verso, permettant une révision active et efficace basée sur la répétition espacée.
Voir toutes les 56 flashcards →Importe ton PDF ou colle ton cours, l'IA génère fiches, QCM et flashcards en 30 secondes.